Usage of Shanghai Yetuo Constant Temperature Water Bath Pot

1. Adding warm water during use can shorten the heating time and save electricity.

2. Turn on the power switch, and the power indicator light will light up to indicate that the power is correctly connected.

3. Set the device to the desired temperature, and when the heating indicator light is on, it indicates that the power supply of the electric heating tube is turned on for heating. When the temperature on the thermometer reaches the desired temperature, wait for a few minutes and then start automatic temperature control.

4. The scale of the constant temperature controller is only for temperature comparison indication, not for temperature indication scale.

Precautions during the use of Shanghai Yetuo constant temperature water bath

1. The outer shell of the box must be effectively grounded.

2. Do not turn on the power before adding water to prevent the heating wire of the electric heating tube from burning out.

3. Do not open the right side differential board unless necessary for safety reasons.

Maintenance and repair of Shanghai Yetuo constant temperature water bath:

1. After use, the power should be turned off.

2. The inside and outside of the box should be kept clean regularly.

3. If the indicator light is not on, turn off the power first, unplug the plug and open the right side plug board. If the fuse or indicator light bulb is damaged, it can be replaced with the same specification.

If the constant temperature control fails, it indicates that the sensor on the controller is malfunctioning. It can be used after replacement.